16K Japanese standard marine flange bronze straight stop check valve is built to JIS F7410. The product is shown as a globe / check valve from our marine valve range: the external form, flange face and operator follow the standard, while the exact size range, pressure class, material grade, trim and end-connection details are confirmed against the project requirements and the order requirements.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | JIS F7410 |
| Type | globe / check valve |
| Nominal size | Project-specific |
| Pressure | 16K (≈1.6 MPa) |
| Body material | Cast bronze body and cover |
| Connection | Flanged, both ends |
| Media | Sea water · fresh water · fuel oil · air |
| Inspection & certificates | CCS · LR · BV · ABS · DNV · ZC |
Final configuration is matched to the project requirements before supply.
| Part | Material | Trademark |
|---|---|---|
| Body and cover | Cast bronze | Exact grade project-specific |
| Disc / plug / stem | Project-specific | Per project requirements |
| Gasket and seat | Project-specific | Per project requirements |
This globe / check valve is supplied for newbuilding, repair and dry-docking work where the piping has to follow the referenced standard. Body, bonnet, disc and seat are produced and machined in-house, then hydrostatic and seat-tested before dispatch. The illustration on this page is a real product photograph, not a generic drawing.
Tell us the nominal size, body material, end connection and required inspection scope, or send a photograph of the existing valve or its nameplate. Where the flange bolt circle, bolt count and face-to-face match the referenced type we supply that type; where they do not, we check the difference before quoting rather than after.
The standard number or drawing, the nominal size, the body material, the end connection, the quantity and whether a classification society certificate is required. A photograph of the existing valve or the nameplate is usually enough for us to identify the rest.
It is selected by purchasing identity: standard, type, nominal size, body material and end connection must all match. Send the old valve details and we check before quotation.
Inspection and certification scope is agreed per project. State the society and the surveyor’s requirements on the enquiry so it is included in the quotation.
Where the bolt circle, bolt count and face-to-face match the referenced type we supply that type. Where they do not, we say so before quoting.
The standard number or the drawing, the DN size, the body material, the quantity, and whether a classification society certificate is required.