JIS F7359 is identified by the source page as a cast-iron 5K angle lift check valve. The standalone photo shows a real angle-pattern body with visible 5K100 and FC markings; check the selected configuration against the approved vessel drawing.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | JIS F7359-1996 |
| Type | Angle lift check valve; physical photo shows side and bottom flanges |
| Nominal size | DN50–DN200 |
| Pressure | JIS 5K |
| Body material | Cast-iron appearance with visible FC marking; exact grade and trim project-specific from project requirements |
| Connection | Flanged angle body; JIS 5K shown |
| Media | Project-specific |
| Inspection & certificates | Project-specific |
Final configuration is matched to the project requirements before supply.
| Part | Material | Trademark |
|---|---|---|
| Body and cover | Cast iron | Exact grade project-specific |
| Disc / stem | Project-specific | Per project requirements |
| Gasket and seat | Project-specific | Per project requirements |
The source page lists JIS F7359-1996, JIS 5K and DN50-DN200. The photo shows a physical 90-degree body with side and bottom flanges, plus visible 5K100 and FC markings, supporting the photographed DN100 example.
The photo depends on the exact cast-iron grade, disc or seat material, face-to-centre dimensions, flow direction, installation orientation or inspection records. Check these items before replacement; this valve should not be treated as a manual shut-off valve without the applicable isolation arrangement.
It shows a real angle-pattern lift-check body with side and bottom flanges and visible 5K100 and FC marks. It does not check the exact grade, trim or dimensions.
F7359 is the angle-body pattern; F7358 is straight-through. Their installation dimensions and flow route differ.
State JIS F7359, DN, JIS 5K, flow direction, flange details, face-to-centre dimensions, medium, temperature and required inspection documents.
Not when manual shut-off is required. Match the existing non-return and isolation duties to the approved piping drawing before selection.
The required inspection scope and documents are agreed for the actual order. This reference photo alone depends on a product approval or certificate scope.