JIS F7351 is the bronze screwdown check valve: a globe body whose disc is guided on the stem, so it works as a non-return valve in normal service and can be wound shut when the line has to be isolated.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | JIS F7351-1996 |
| Type | Screwdown check (SDNR), globe pattern |
| Nominal size | DN15–DN40 |
| Pressure | 5K (0.5 MPa) |
| Body material | BC6 cast bronze body and bonnet |
| Connection | Flanged, both ends |
| Media | Sea water · fresh water · fuel oil |
| Inspection & certificates | CCS · LR · BV · ABS · DNV · ZC |
| Part | Material | Trademark |
|---|---|---|
| Body, bonnet | Cast bronze | BC6 (CAC406) |
| Disc | Cast bronze | BC6 |
| Stem | Brass / stainless steel | C3771 / SUS403 |
| Seat | Integral bronze | — |
The point of an SDNR is that it does two jobs with one body. A plain check valve cannot be closed for maintenance; a plain globe valve cannot stop reverse flow on its own. The guided disc is free to lift off the seat under forward flow, and the handwheel can press it back down against the seat when you need a positive shut-off.
Because the disc is guided rather than free-floating, it does not chatter on pulsating service - which is why this pattern is standard on pump discharges and on lines where a swing check would hammer.
Yes, and that is how most ships run it. Wind the handwheel up and leave it: the disc then behaves as a normal lift check and closes on reverse flow by itself.
F7356 has no stem and no handwheel - it can only be closed by reverse flow. F7351 adds the stem so you can shut it manually. Same body family, different bonnet.
Yes. CCS, LR, BV, ABS, DNV and ZC inspection can be arranged before dispatch, and the certificate is issued against the actual heat number of the casting. State the society and the surveyor's requirements on the enquiry so it is included in the quotation rather than added later.
Our production follows the Chinese national (GB/CB) standards and customer drawings. If the part you are replacing follows JIS, DIN, EN or an IMPA-coded pattern, send the drawing or the flange dimensions: where the bolt circle, bolt count and face-to-face match a GB/CB type, we supply that type. Where they do not, we say so before quoting rather than after.
Five things decide the price: the standard number or the drawing, the DN size, the body material, the quantity, and whether a classification society certificate is required. A photo of the nameplate or the old valve is usually enough for us to identify the rest. Delivery port and required date help, but they are not needed for the first reply.