JIS F3057 is the bronze vertical storm valve: inlet horizontal, outlet straight down through the shell or deck, with a rubber-faced flap that closes on its own weight when the sea pushes back. Bronze is specified where the discharge is small-bore and the body will spend its life wet.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | JIS F3057-1996 |
| Type | Vertical, gravity flap |
| Nominal size | DN40–DN200 |
| Pressure | 5K (0.5 MPa) |
| Body material | BC6 cast bronze body and cover |
| Connection | Flanged, both ends |
| Media | Sea water · fresh water · fuel oil |
| Inspection & certificates | CCS · LR · BV · ABS · DNV · ZC |
| Part | Material | Trademark |
|---|---|---|
| Body, bonnet | Cast bronze | BC6 (CAC406) |
| Disc | Cast bronze | BC6 |
| Stem | Brass / stainless steel | C3771 / SUS403 |
| Seat | Integral bronze | — |
There is no stem and no gland, so there is nothing to pack, grease or seize. The flap hangs on a single hinge pin above the seat and only the cover has to come off for inspection, which is what the surveyor wants to see at the next dry-docking.
Because the body is one bronze casting with no ferrous wetted parts, F3057 suits sanitary and grey water overboard lines where a steel body would need coating renewal every few years. The flap can be supplied with NBR or PTFE facing depending on the discharge.
F3057 is the bronze body, F3058 the cast steel body. Same flap and same flange drilling, so the choice is the medium and the size: bronze up to about DN200 for corrosive discharge, cast steel where the line is larger or the discharge is shared with a bilge main.
Yes. Remove the cover, draw the hinge pin and lift the flap out - no special tooling and no need to cut the pipe. We supply spare flaps and hinge pins against the valve DN.
Yes. CCS, LR, BV, ABS, DNV and ZC inspection can be arranged before dispatch, and the certificate is issued against the actual heat number of the casting. State the society and the surveyor's requirements on the enquiry so it is included in the quotation rather than added later.
Our production follows the Chinese national (GB/CB) standards and customer drawings. If the part you are replacing follows JIS, DIN, EN or an IMPA-coded pattern, send the drawing or the flange dimensions: where the bolt circle, bolt count and face-to-face match a GB/CB type, we supply that type. Where they do not, we say so before quoting rather than after.
Five things decide the price: the standard number or the drawing, the DN size, the body material, the quantity, and whether a classification society certificate is required. A photo of the nameplate or the old valve is usually enough for us to identify the rest. Delivery port and required date help, but they are not needed for the first reply.