GB/T3036-94 with a hydraulic actuator: a cylinder driving the quarter-turn through a lever or a yoke, worked at 60–120 bar from the ship's hydraulic power pack. Chosen where very high seating torque or a fast, repeatable stroke is needed.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | GB/T3036-94 |
| Type | Hydraulic double-acting |
| Nominal size | DN80–DN600 |
| Pressure | 0.6 / 1.0 MPa |
| Body material | HT200 cast iron body, bronze or stainless disc |
| Connection | Flanged, both ends |
| Media | Sea water · ballast · cargo oil |
| Inspection & certificates | CCS · LR · BV · ABS · DNV · ZC |
| Part | Material | Trademark |
|---|---|---|
| Body | Cast iron | HT200 |
| Disc | Nodular iron, nylon coated / bronze | QT450-10 / ZCuSn10Zn2 |
| Stem | Stainless steel | 2Cr13 |
| Seat | Bonded rubber / PTFE | NBR / EPDM / PTFE |
Hydraulic actuation gives the highest torque per unit size of any drive, which is why it is used on large cargo valves and on quick-closing valves for fuel oil in a machinery space. A self-contained hand pump can be fitted for emergency operation.
The cylinder is matched to the valve torque at the specified differential pressure, not just to the DN, so give the line pressure and the fluid when ordering — an under-sized cylinder will fail to seat against full pressure.
From the valve torque at the line pressure plus a 1.5 safety factor. Give us the medium, pressure and whether the valve must close against flow.
Yes — for fuel oil service the actuator can be set to close in under five seconds on a signal loss, with the closing time proven on test and recorded.
Yes. CCS, LR, BV, ABS, DNV and ZC inspection can be arranged before dispatch, and the certificate is issued against the actual heat number of the casting. State the society and the surveyor's requirements on the enquiry so it is included in the quotation rather than added later.
Our production follows the Chinese national (GB/CB) standards and customer drawings. If the part you are replacing follows JIS, DIN, EN or an IMPA-coded pattern, send the drawing or the flange dimensions: where the bolt circle, bolt count and face-to-face match a GB/CB type, we supply that type. Where they do not, we say so before quoting rather than after.
Five things decide the price: the standard number or the drawing, the DN size, the body material, the quantity, and whether a classification society certificate is required. A photo of the nameplate or the old valve is usually enough for us to identify the rest. Delivery port and required date help, but they are not needed for the first reply.