GB/T3036-94 A is the wafer-pattern butterfly valve in cast bronze: the body is clamped between two counter-flanges, the disc is bronze and the seat is bonded elastomer. Specified on sea water and fire mains where a cast iron body would need coating.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | GB/T3036-94 |
| Type | A · wafer body, bronze, lever |
| Nominal size | DN50–DN300 |
| Pressure | 0.6 / 1.0 MPa |
| Body material | ZCuSn10Zn2 cast tin bronze body |
| Connection | Flanged, both ends |
| Media | Sea water · fresh water · fire main |
| Inspection & certificates | CCS · LR · BV · ABS · DNV · ZC |
| Part | Material | Trademark |
|---|---|---|
| Body | Cast iron / cast steel / bronze | HT200 / ZG230-450 / ZCuSn10Zn2 |
| Disc | Bronze / stainless steel | ZCuSn10Zn2 / 1Cr18Ni9Ti |
| Stem | Stainless steel | 2Cr13 / 1Cr18Ni9Ti |
| Seat ring | Rubber / PTFE | NBR / PTFE |
The bronze wafer body is the answer to a coated cast iron valve on a seawater line: no paint to fail, no rust bleed, and the same face-to-face as the iron pattern so it is a direct substitution at build or at refit.
Being a wafer, it needs both counter-flanges and their gaskets to hold; it cannot dead-end. Four through-bolts or a set of studs carry the clamping load, so check the bolt length when replacing an iron wafer with this one.
Same face-to-face to the standard, so it drops into the same gap — but the through-bolts must be long enough for the extra body thickness at the lugs.
Yes, and bronze is the usual choice there; check that the elastomer is approved for the medium and that the valve is in the survey scope.
Yes. CCS, LR, BV, ABS, DNV and ZC inspection can be arranged before dispatch, and the certificate is issued against the actual heat number of the casting. State the society and the surveyor's requirements on the enquiry so it is included in the quotation rather than added later.
Our production follows the Chinese national (GB/CB) standards and customer drawings. If the part you are replacing follows JIS, DIN, EN or an IMPA-coded pattern, send the drawing or the flange dimensions: where the bolt circle, bolt count and face-to-face match a GB/CB type, we supply that type. Where they do not, we say so before quoting rather than after.
Five things decide the price: the standard number or the drawing, the DN size, the body material, the quantity, and whether a classification society certificate is required. A photo of the nameplate or the old valve is usually enough for us to identify the rest. Delivery port and required date help, but they are not needed for the first reply.