GB/T1855-93 S/SS combines shut-off and non-return valves in one three-valve chest: the globe-check valves stop backflow into the manifold while still allowing each branch to be shut by hand.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | GB/T1855-93 |
| Type | S · SS (with drain) |
| Nominal size | DN15–DN50 branches |
| Pressure | 0.2 MPa |
| Body material | HT200 cast iron body, bronze trim |
| Connection | Flanged, both ends |
| Media | Bilge water · ballast water · sea water |
| Inspection & certificates | CCS · LR · BV · ABS · DNV · ZC |
| Part | Material | Trademark |
|---|---|---|
| Chest body | Cast iron | HT200 |
| Bonnet | Cast iron | HT200 |
| Disc | Cast iron with bronze facing | HT200 / ZCuSn10Zn2 |
| Stem | Tin brass | HSn62-1 |
| Gasket | Rubber bonded fibre | — |
On a bilge or ballast manifold, backflow is the failure that matters — a branch left open can put sea water into a dry compartment. A globe-check chest gives each branch a non-return function as well as a handwheel, without adding a separate check valve per line.
The check element is inside the same bonnet as the globe disc, so the number of flanges and gaskets is unchanged from the plain GB/T1854 chest. S is plain, SS adds the drain tapping.
1855 gives each branch a non-return function. If the manifold can see pressure from both sides — ballast cross-connections are the usual case — that is the reason to pay for it.
Only the disc and seat, and they are reached through the same bonnet as the globe disc, so there is no extra joint to break.
Yes. CCS, LR, BV, ABS, DNV and ZC inspection can be arranged before dispatch, and the certificate is issued against the actual heat number of the casting. State the society and the surveyor's requirements on the enquiry so it is included in the quotation rather than added later.
Our production follows the Chinese national (GB/CB) standards and customer drawings. If the part you are replacing follows JIS, DIN, EN or an IMPA-coded pattern, send the drawing or the flange dimensions: where the bolt circle, bolt count and face-to-face match a GB/CB type, we supply that type. Where they do not, we say so before quoting rather than after.
Five things decide the price: the standard number or the drawing, the DN size, the body material, the quantity, and whether a classification society certificate is required. A photo of the nameplate or the old valve is usually enough for us to identify the rest. Delivery port and required date help, but they are not needed for the first reply.