CB907-94 is the bronze right-angle liquid safety valve used to protect pumps, coolers and pipe sections from over-pressure. The outlet turns 90° so the discharge can be led to a safe place without an extra bend.
Key information for selection. Send your drawing or nameplate photo for an exact match.
| Item | Value |
|---|---|
| Standard | CB907-94 |
| Type | Right-angle, male thread |
| Nominal size | DN15–DN50 |
| Pressure | 0.5 MPa |
| Body material | ZCuSn10Zn2 cast tin bronze |
| Connection | Flanged, both ends |
| Media | Sea water · fresh water · lube oil |
| Inspection & certificates | CCS · LR · BV · ABS · DNV · ZC |
| Part | Material | Trademark |
|---|---|---|
| Body, bonnet | Cast tin bronze | ZCuSn10Zn2 |
| Disc | Cast tin bronze | ZCuSn10Zn2 |
| Stem | Tin brass | HSn62-1 |
| Packing | PTFE / graphite | — |
Set pressure is adjusted by a screw under the cap and locked with a sealing wire; the valve is supplied set to the pressure you state on the order and labelled with that figure.
The angle outlet is the reason this pattern is used on pump discharge manifolds, where a straight relief valve would discharge into the adjacent pipe.
State the design pressure of the protected section and we set the valve 10 % above it, or to the figure your drawing requires. The set pressure is stamped on the body.
It can, by removing the cap and turning the adjusting screw, but the new setting should be re-sealed and recorded — surveyors normally expect a bench certificate.
Yes. CCS, LR, BV, ABS, DNV and ZC inspection can be arranged before dispatch, and the certificate is issued against the actual heat number of the casting. State the society and the surveyor's requirements on the enquiry so it is included in the quotation rather than added later.
Our production follows the Chinese national (GB/CB) standards and customer drawings. If the part you are replacing follows JIS, DIN, EN or an IMPA-coded pattern, send the drawing or the flange dimensions: where the bolt circle, bolt count and face-to-face match a GB/CB type, we supply that type. Where they do not, we say so before quoting rather than after.
Five things decide the price: the standard number or the drawing, the DN size, the body material, the quantity, and whether a classification society certificate is required. A photo of the nameplate or the old valve is usually enough for us to identify the rest. Delivery port and required date help, but they are not needed for the first reply.