Categories
Categories

How a storm valve is tested before it leaves the works

Shell test, seat test, then a dimensional check against the drawing. Here is the sequence every storm and scupper valve goes through.
Oct 21st,2026 3 Views

A storm valve is the last line of defence for a deck drain. If it fails closed, the " engine room floods. That is why the test sequence matters more than the sales sheet.

1. Shell test

The assembled body is filled and pressurised with water at 1.5 times the design pressure, " held for the time required by the applicable standard, and inspected for leakage at every " joint, seam and casting repair. No weeping, no misting, no drop in gauge pressure.

2. Seat test

With the disc closed, pressure is applied to each side in turn. The acceptance criterion " depends on the seat material and the standard you are working to — metal seats and " rubber seats are not judged the same way, and a metal-seated valve that passes a soft-seat " acceptance figure is not necessarily a better valve.

3. Dimensional and marking check

Face-to-face, flange drilling, and the marking — size, pressure class, material, " heat number, flow arrow. A valve that passes pressure but carries the wrong heat number is " still a rejected valve, because the traceability chain is broken.

4. Records

Each unit leaves with a hydrostatic test record and a material certificate for the " pressure-bearing parts. If the vessel is classed, those documents are what the surveyor " asks for first.

Ask us for a sample test record with your enquiry and we will send a redacted copy so " you can see the format before you place an order.